Dial Intercom; To Initiate; To Answer; Internal Zone Paging With Meet-Me Page - NEC UNIVERGE DT930 User Manual

DIAL INTERCOM

Dial Intercom comprises up to 10 terminals that can
call each other using a dedicated Dial Intercom
feature key with abbreviated dialing. Dial Intercom
calls can be voice announce with ringing calls.
The feature key is set by system data
setting at initial installation. For details,
please contact the system
administrator.

TO INITIATE

1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
2.
Press Dial Intercom feature key.
Dial Intercom feature key lamp lights green.
3.
Dial desired intercom terminal number ( "0"- "9").
4.
Press "1".
Change to ring tone signal.
Tone burst is sent.

TO ANSWER

1.
While hearing ringing tone,
Dial Intercom feature key lamp flashes green.
Tone burst or ring tone is heard.
2.
Press Dial Intercom feature key.
Dial Intercom feature key lamp lights green.
3.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
INTERNAL ZONE PAGING WITH
MEET-ME PAGE
This feature allows terminal users to page over the
built-in speakers of the terminals within the
assigned zone or all zones.
The feature access code/feature key is
set by system data setting at initial
installation. For details, please contact
the system administrator.

TO PAGE (TERMINAL A)

The terminal A pages the terminal B.
1.
Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red.
2.
Dial Internal Paging access code fordesired zone
or all zones or press Internal Paging feature key
assigned for desired zone or all zones.
3.
Page the terminal B.

TO ANSWER (TERMINAL B)

1.
Dial Meet-Me Answer access code.
They are immediately connected.
76
FEATURE OPERATION