ITech IT-M3900C Series User Manual page 130

•
•
Select Curve file
You can select the Curve file saved in the instrument to be in the Open state for
later running.
1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-
2. Use knob to select 4. SAS: Off and press [Enter].
Curve
The steps to edit a static curve locally on the instrument are as follows:
1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to
enter the function menu.
2. Use knob to select 4. SAS: Off and press [Enter].
3. Press the Left/Right key to select Static and press [Enter].
4. Press the Left/Right key to select Curve and press [Enter].
5. Press the Left/Right key to select Edit and press [Enter].
6. Set the Pmp, Vmp and Formula in turns, and press [Enter].
7. Set the saved file name and press [Enter].
– Also you can set the filter speed in SAS→Filter according to the ac-
tual test needs.
– After the above Curve parameters are set completely, you can press
[Esc] until you return to the SAS main interface and select Run to
trigger the current edited Curve file to run.
User-defined
The steps to edit a custom curve are as follows:
1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to
enter the function menu.
2. Use knob to select 4. SAS: Off and press [Enter].
3. Press the Left/Right key to select Static and press [Enter].
4. Press the Left/Right key to select User-defined and press [Enter].
5. Set the Voc, Imp and the other parameters, and press [Enter].
After the setting is completed, the system returns to the main interface of
the SAS function, and the currently edited custom curve is to be run. The
interface is displayed as follows:
FUNCTION SAS
Run Vmax Static
ter the function menu.
Copyright © Itech Electronic Co., Ltd.
Table Filter
Power Supply Function
119