13. AUTOMATION SETUP
13.5. Automation setup for Christie ACT devices
The SR-1000 supports the Christie ACT automation device. Follow the steps below to configure
a Christie ACT device in the server automation interface.
1. Under the Automation tab in the menu, click the Device sub-tab.
2. Under the
Device
3. Select 'ChristieACT' as the device Type. Enter the
click OK.
4. Enter the
IP Address
5. The default setting for
this value if required.
6. Default
Control Cues
can be added or removed by clicking the
7. Click
Save
to save the settings.
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK™
INSTALLATION MANUAL
list on the left, click on the
of the ChristieACT device.
Port
is displayed on the settings for the ChristieACT device. Change
will be set up for a new ChristieACT automation device. Control cues
+
Figure 41: Christie device setting
Create
button.
Name
of the ChristieACT device and
–
or
buttons.
- 38 -
nd
December 22
, 2022