Install The Control Unit (Panel Enclosure) - Carl Valentin SPE II 106/12 Operating Manual

SPE II
11.20

5.2 Install the Control Unit (Panel Enclosure)

•
At the side panels of the control unit (A) are two threads M5 which
can be used for the attachment of the control unit at a machine.
The maximum thread depth is 6 mm.
•
At the back panel of control unit (A) are four threads M6 (C) in
distance of 57 x 57 mm which can be used for the attachment of
the control unit at a machine.
The maximum thread depth is 8 mm.
•
Ex works optionally a mounting bracket (E) is offered which can
be used to the pivoting support of control unit (A) to the threaded
holes (B). The mounting bracket can be fastened standing or
hanging with four screws M6 (D) at a machine.
•
Ex works optionally a fixing flange Ø 30 mm or a base clamp
Ø 30 mm are offered which can be used to the support of the
control unit (A) at the threaded holes (C). The clamping pieces (F)
can be integrated into a piping system Ø 30 mm.
F
E
Figure 11
Operating Manual
C
D
Installation
A
B
31