Table of Contents
Advertisement
Function Menu
Number of columns
Material
Flip label
Rotate label
Rotate label (in °)
Alignment
Label type
56
8.4 Label Settings
8.4.1
Label Layout
Indication how many labels are sidy by side on the liner. With column
printing, the label width is to be changed to the width of the layout
(see chapter 11.1, page 107).
Selection of the used label and transfer ribbon material.
The axis of reflection is in the middle of the layout. If the label width
was not transferred to the printing system, automatically the default
label width i.e. the width of the printhead is used. It is recommended
to use labels with the same width as the printhead. Otherwise this can
cause problems in positioning.
According to standard the label is printed ahead with a rotation of 0°. If
the function is activated, the label is rotated by 180° and printed in
reading direction.
Corresponding to the parameter Rotate label, the label can be turned
in 90° steps.
NOTICE!
Only printer internal objects (text, lines and barcodes) can be
turned. The rotation of graphics is not possible.
The adjustment of label is effected only after Flip/Rotate label, i.e. the
adjustment is independent of the functions Flip label and Rotate label.
Left: The label is aligned at the left-most position of printhead.
Centre: The label is aligned at central point of printhead.
Right: The label is aligned at right-most position of printhead.
8.4.2
Label Recognition
Selection of adhesive labels or continuous material is used in the
printing system. As default, adhesive labels is set. If the menu item
Label length/Gap length contains a gap value, this value is added to
the label length.
Operating Manual
SPE II
11.20
Advertisement
Table of Contents
