Clean The Printhead - Carl Valentin SPE II 106/12 Operating Manual

Maintenance and Cleaning
84

9.4 Clean the Printhead

Printing can cause accumulation of dirt at printhead e.g. by colour
particles of transfer ribbon, and therefore it is necessary to clean the
printhead in regular periods depending on operating hours,
environmental effects such as dust etc.
CAUTION!
Printhead can be damaged!

Do not use sharp or hard objects to clean the
printhead.

Do not touch the protective glass layer of the
printhead.
Figure 22
1. Open the cover of printing system.
2. Turn the lever (A, Figure 21) counter clockwise to lift up the
printhead.
3. Remove labels and transfer ribbon from the printing system.
4. Clean the printhead surface with a special cleaning pen or a
cotton swab dipped in pure alcohol.
5. Before using the printing system, let the printhead dry for about
two to three minutes.
Operating Manual
SPE II
Focal line
11.20