Corner Type - Load Media; Load Label Roll - Carl Valentin SPE II 106/12 Operating Manual

SPE II
Load label roll in
dispenser mode
11.20
Corner Type – Load Media
7

7.1 Load Label Roll

J
I
H
G
F
E
Figure 18
1. Open the cover of print module.
2. Open the printhead (I) by turning the pressure lever (J)
anticlockwise.
3. Pull up the latch of the bearing rail to open the bearing rail (A).
4. Lead the label material below the label guiding (B) and printhead
(I) and take care that the labels run through the photocell (C).
5. Press the bearing rail (A) down again until it engages.
6. Move the printhead (I) down by turning the pressure lever (J) in
clockwise direction until it locks.
7. Adjust the adjusting rings (D) of the label guiding to the width of
material.
8. Turn the locking lever (G) upwards in clockwise direction while
turning the dispenser whip (E) downwards.
9. Remove some labels from the supporting paper and feed the
material over the dispensing edge (H) and between the groove
plastic roller (F) and the shaft of the dispensing whip (E).
10. Press again the dispensing whip (E) to the top and lock it.
11. Lead the supporting paper backwards and fix it at the rewinding
unit.
12. Enter the offset value in menu Dispenser I/O.
13. Close the cover of print module.
Operating Manual
Corner Type – Load Media
A
B
C
D
43