Passing Mode - Carl Valentin SPE II 106/12 Operating Manual

Flat Type – Load Media
Load label roll in

passing mode

40
E
D
Figure 16
1. Open the cover of print module.
2. Open the printhead (D) by turning the pressure lever (E)
anticlockwise.
3. Lead the label material below the label guiding (B) and printhead
(D) and take care that the labels run through the photocell (A).
4. Move the printhead (D) down by turning the pressure lever (E) in
clockwise direction until it locks.
5. Adjust the adjusting rings (C) of the label guiding to the width of
material.
6. Close the cover of print module.
Operating Manual
SPE II
A
B
C
11.20