Replace The Printhead (Corner Type) - Carl Valentin SPE II 106/12 Operating Manual

SPE II
Remove the printhead
Install the printhead
11.20

9.9 Replace the Printhead (Corner Type)

C
Figure 28
1. Remove labels and transfer ribbon from the printing system.
2. When the printhead is closed, loosen the hex (Allen) screws (C).
3. Turn the lever (A) counter clockwise to lift up the printhead (B).
4. If the printhead (B) is not disengaged on the print roller, continue
loosen the hex (Allen) screws (C).
5. Remove the printhead carefully to the front until you can reach the
plug connections.
6. Remove the plug connections and then remove printhead (B).
1. Attach the plug connections.
2. Position the printhead in the printhead mounting bracket in such a
way that the pin is secured in the corresponding hole in the head
plate.
3. Lightly keep the printhead mounting bracket on the pressure roller
with one finger and check for correct positioning of the printhead.
4. Tighten again the screws (C).
5. Reload labels and transfer ribbon (see chapter 7 Corner Type –
Load Media, page 43).
6. Check the resistance value on the type plate of printhead and if
necessary change the value in the Service functions/heater
resistance.
Operating Manual
Maintenance and Cleaning
C B A
91