Print Control; Print Control; User Environment - Carl Valentin SPE II 106/12 Operating Manual

Function Menu
Backfeed
Manual reprint
CMI length
Label confirmation
Standard label
Buzzer
60
8.5.2

Print Control

Backfeed mode: The backfeed was optimised in the operating modes
dispenser (optional) and cutter (optional). Now, when driving into the
offset, the following label is 'pre-printed' if possible and therefore the
backfeed of label is no necessary and time can be saved.
Auto backfeed delay: The adjustable delay time is only important
with mode 'backfeed automatic' (see chapter 11.3, page 109.
On: If the printing system is e.g. in stoppin mode after an error, the
last printed label can be reprinted with the key 'Reprint'.
Off: Only empty layouts are moved forward.
If the print is interrupted in the label, at the printhead this could lead to
a small interruption in the printout, showing a fine white line onto the
label. To avoid this, a value for the minimum backfeed can be set (0 –
1 mm) at which the label material is moved backwards. At the next
print start the free range is overprinted. The setting of CMI length has
only an influence at the selection of backfeed mode 'optimised
backfeed'.
On: A new print order is only printed after confirmation at the device.
An already active continuing print order is printed as long as the
confirmation is effected at the device.
Off: No query appears at the display of control unit.
On: If a print order is started without previous definition of label, the
standard label is printed.
Off: If a print order is started without previous definition of label, an
error message appears in the display.
8.5.3

User Environment

On (1-7): An acoustic signal is audible when pressing a key.
Off: No signal is audible.
Operating Manual
SPE II
11.20