Load Transfer Ribbon - Carl Valentin SPE II 106/12 Operating Manual

SPE II
11.20

7.2 Load Transfer Ribbon

NOTICE!
For the thermal transfer printing method it is necessary to load
a ribbon, otherwise when using the printing system in direct
thermal print it is not necessary to load a ribbon. The ribbons
used in the printing system have to be at least the same width
as the print media. In case the ribbon is narrower than the print
media, the printhead is partly unprotected and this could lead
to early wear and tear.
E
D
C
Figure 20
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must
be cleaned using printhead and roller cleaner (97.20.002). For
detailed information, please see page 84.
The handling instructions for the use of Isopropanol (IPA) must
be observed. In the case of skin or eye contact, immediately
wash off the fluid thoroughly with running water. If the irritation
persists, consult a doctor. Ensure good ventilation.
1. Open the cover of print module.
2. Open the printhead (C) by turning the pressure lever (D)
anticlockwise.
Operating Manual
Corner Type – Load Media
A
B
45