Removing The System Interconnect Board - ZOLL M Series Service Manual

M Series Service Manual
9. Removing the
System
Interconnect
Board
Tools Required
• #2 Phillips screwdriver
Setup
1. Remove the Front Panel Assembly.
2. Remove the Upper Housing Assembly.
3. Remove the System Board.
4. Remove the Battery Interconnect Board.
5. Remove the High Voltage/Charger module.
6. Remove the clear plastic print head isolater.
7. Remove the motor cable, cable print head and
paper sensor cable.
To reinstall the System Interconnect Board:
1. Install the laminate cables and keepers.
2. Ensure that the PCMCIA slots with gaskets are
located to the right rear of the board and seated
properly.
3. Install two screws.
4. Reconnect all the cables and reverse the steps.
Step 1: Remove the clear plastic head isolater.
.
Step 3: Disconnect the cables and lift the System
Interconnect Board out of the unit.
cable print head
paper sensor
cable
79
Step 2: Remove two screws from each side of the
System Interconnect Board.
motor cable