Removing The Control Board (Continued) - ZOLL M Series Service Manual

M Series Service Manual
2B. Removing the
Control Board
(Continued)
To reinstall the Control Board
1. Set the dip switches and attach the SHOCK
button LED actuator.
2. Place a small amount of strong glue on the
end of the mode selector switch. Slide the
replacement knob on. After the glue dries,
rotate the selector knob to ensure that it is
properly glued in place.
3. Replace the Pacer Output/Rate knobs, if
applicable.
Step 5: Disconnect the speaker microphone cable.
Remove the Control Panel Board from the Front
Panel Assembly. Important: Note the position of the
dip switches because they must be in the same
position for reinstallation.
70
Step 6: Remove the 50 pin laminate cable from the
control board. See 1.0 Removing the ZIF Keeper.
50 pin laminate cable