Removing The Band - ZOLL AutoPulse NXT User Manual

7. Insert the large end of the pin into the opposite hole. With your fingers under the belt press in the pin
and snap into place.
8. Insert the short side of the band guard into the top of the guard port.
9. Push the long side of the band guard into the bottom of the guard port.
10. Push the short side of the band guard again, fully snapping the band guard into the guard port.
11. Repeat Step 3 through Step 10 on the other side of the platform.
12. Turn on the platform.
Note. If the band retracts into the platform, see "Retracting bands" on page 64.
13. Check the band guard lock indicators on the "User control panel" (page 10) are not flashing. If either
band guard lock indicator is flashing, check that the band guard is correctly installed on the platform.

Removing the band

Caution. Do not cut the band before removing from the platform. See "Cut bands" on page 63.
1. Place the platform, with the patient surface facing up on a smooth, flat surface.
AutoPulse NXT User Guide
Chapter 4. Band
19