M Series Service Manual
5. Removing the
Battery
Interconnect
Board Assembly
Tools Required
• Orange stick
Setup
1. Remove the Front Panel Assembly.
2. Remove the Upper Housing Assembly
3. Remove the System Board Battery Cable.
To reinstall the Battery Interconnect Board,
reverse the steps.
Note: For Step 4, remember to carefully remove
the cable from the Charger Assembly when
disassembling and reinstalling it.
Step 1: Identify the Battery Interconnect Board.
.
Step 3: Remove the push pin and small insert collar.
74
Step 2: Remove the wide laminate cable from the
high voltage module connector by lifting the cable
vertically.
Step 4: Rotate the unit around so that the rear of the
unit faces you. Rotate the Battery Interconnect Board
upwards toward the front of the device. Hold the
board vertically while removing the 10-pin laminate
cable from connectors by lifting the connector lock.
charger cable
10 pin laminate cable