Removing the Monitor Board and SpO
Tool Required
# 1 Phillips screwdriver with torque capability
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 55
2.
3.
4.
5.
To reinstall the monitor board and/or SpO
Monitor Board and/or SpO
1
2
3
9650-000821-01 Rev. C
"Disassembling the Main Unit" on page 56
"Removing the Front Enclosure Module" on page 58
"Removing the Display Module" on page 60
"Removing the EtCO2 and NIBP Modules" on page 63
Disassembly
2
Remove four (4) screws on the right side of
the unit in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
Remove four (4) screws on the left side in
the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
Turn the unit over.
Propaq M Service Manual
Removing the Monitor Board and SpO2 Modules
modules, reverse the steps.
2
Modules
2
shield
65