Initialize The Tpm For Bitlocker Users; Initialize The Tpm 1.2 For Txt Users; Installing The Tpm - Dell EMC VxFlex Ready Node R840 Manual

Initialize the TPM for BitLocker users

Initialize the TPM 1.2 for TXT users

3. Press the plastic rivet until the rivet snaps into place.
Figure 94 Installing the TPM
After you finish
Continue by installing the system board. See
Procedure
1. Initialize the TPM.
The TPM Status changes to Enabled, Activated.
For more information, see
cc753140.aspx.
Procedure
1. While booting the system, press F2 to enter System Setup.
2. In the System Setup Main Menu screen, click System BIOS
Security Settings .
3. From the TPM Security option, select On with Pre-boot Measurements.
4. Set the TPM Command option to Activate.
5. Save the settings.
6. Restart the system.
7. Enter System Setup again.
8. On the System Setup Main Menu screen, click System BIOS
Security Settings.
9. Set the Intel TXT option to On.
Common procedures for replacing system components
Install the system board
https://technet.microsoft.com/en-us/library/
Initialize the TPM for BitLocker users
on page 143.
System
>
System
>
179