Installing The Expansion Card Into A Riser - Dell EMC VxFlex Ready Node R840 Manual

Hardware FRU procedures
Install the expansion card risers
VxFlex Ready Node R840 Hardware Field Replacement Unit and Service Manual
106
Figure 41 Installing the expansion card into a riser
Before you begin
Follow all safety guidelines.
Procedure
1. If removed, install the expansion cards into the expansion card risers.
2. Holding the touch points, align the slots on the riser with the guides on the
system board and air shroud.
3. Lower the expansion card riser into place until the expansion card riser
connector is fully seated in the connector.
4. Tighten the captive screws to secure the riser to the system.