System Bios - Dell EMC VxFlex Ready Node R840 Manual

System BIOS

System information
iDRAC Settings
Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface for setting up and configuring the iDRAC
parameters using the UEFI (Unified Extensible Firmware Interface). You can
enable or disable various iDRAC parameters using the iDRAC settings utility. For
more information about this utility, see Integrated Dell Remote Access Controller
User's Guide at Dell.com/idracmanuals.
Device Settings
Enables you to configure device settings such as network cards or storage
controllers.
You can use the System BIOS screen to edit specific functions such as boot order,
system password, setup password, set the SATA and PCIe NVMe RAID mode, and
enable or disable USB ports.
The System Information screen allows you to view system properties such as the
service tag, system model name, and BIOS version.
View system information
To view system information, perform the following steps:
Procedure
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
Note
If your operating system begins to load before you press F2, wait for the system
to finish booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Information.
System Information details
The System Information screen details are explained as follows:
System Model Name
Specifies the system model name.
System BIOS Version
Specifies the BIOS version installed on the system.
System Management Engine Version
Specifies the current version of the Management Engine firmware.
Managing basic system settings using the system firmware
System BIOS
27