Installing The Processor Bracket - Dell EMC VxFlex Ready Node R840 Manual

Note
Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1
indicator on the processor.
2. Flex the outer edges of the bracket around the processor ensuring that the
processor is locked into the clips on the bracket.
Note
Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator
on the processor before placing the bracket on the processor.
Note
Ensure that the processor and the bracket are placed in the tray before you
install the heat sink.
Figure 58 Installing the processor bracket
3. If you are using an existing heat sink, remove the thermal grease from the heat
sink by using a clean lint-free cloth.
4. Use the thermal grease syringe included with your processor kit to apply the
grease in a quadrilateral design on the top of the processor.
CAUTION
Applying too much thermal grease can result in excess grease coming in
contact with and contaminating the processor socket.
Note
The thermal grease syringe is intended for single use only. Dispose the syringe
after you use it.
Installing the processor into a processor and heat sink module
Hardware FRU procedures
131