Install the BOSS card onto expansion card riser 1
Figure 12 Installing the M.2 module
1. module connector (2)
2. screws (2)
3. modules (2)
Before you begin
Follow all safety guidelines.
Procedure
1. Pull the expansion card latch out of the slot.
2. Hold the BOSS card by its edges, and align the card edge connector with the
expansion card connector on the riser.
3. Insert the BOSS card edge connector firmly into the expansion card connector
until the card is fully seated.
4. Push the expansion card latch into the slot.
Install the BOSS card onto expansion card riser 1
Hardware FRU procedures
63