Table of Contents
Advertisement
Installing the Software,
Installing Touchscreen
Software (Windows 3.1)
(continued)
Calibrating Touchscreen
Software (Windows 95)
Calibrating Touchscreen
Software for Windows 3.1
Continued
4.
When the installation is completed, the system displays the C:\TOUCH>
prompt. Proceed to the section titled "Calibrating Touchscreen Software for
Windows 3.1" to continue the touchscreen software installation.
This section describes how to calibrate Touchscreen software in Windows 95.
1.
Click the Start button to invoke the Windows 95 system menu, and choose
Settings, then Control Panel.
2.
Double-click Elo Touchscreen to run the Touchscreen Control Panel.
3.
Click the Calibrate button and touch each of the three targets as they appear
on the screen. Click Yes when the cursor lines up correctly with your
finger.
4.
Click OK to close the Touchscreen Control Panel.
Windows 3.1 Touchscreen Software is calibrated in two stages: First, through
MS-DOS, then through Windows 3.1. You must complete the steps for MS-
DOS calibration or the drivers will not load properly on system startup in
Windows.
To calibrate the Touchscreen software, perform the following steps:
1.
At the MS-DOS C:\TOUCH > prompt, type GO. The system displays
instructions on the screen to perform the calibration. Touch the screen in the
indicated locations to complete MS-DOS calibration.
2.
When completed, remove the diskette from Drive A.
3.
Perform a warm system boot, by holding down the Ctrl and Alt keys before
pressing the Delete key. The computer will start up in Windows.
4.
From Windows Program Manager, select the Main Program icon.
5.
From the Main Program group, select the Control Panel icon, then select
the Touchscreen icon.
6. On the Touchscreen Menu, ensure that Mode 6 is selected.
7.
Hold down the ALT key, then press C to begin Touchscreen Calibration.
The system displays instructions on the screen to perform the calibration.
8.
Follow the directions on the screen. If the calibration is successful, select
OK. If the calibration is not successful, select NO to retry the calibration.
When calibration is completed, exit the Touchscreen software and the
Windows Control Panel.
3-8
firealarmresources.com
Continued on next page
Advertisement
Table of Contents
