Table of Contents
Advertisement
Installing and Operating the SPC 2120 Utility
Introduction
Requirements
Installation Procedure
Note:
Disregard this section if you do not have a 2120 interface.
This section describes the necessary steps to install and configure the 2120 Serial
Point Collection Utility (SPC 2120).
For further information, consult the following publications:
• Publication No. 574-097 – Multiport SLI Option Installation Instructions
• Publication No. 574-122 – Field Installation of the 2120 Multiport SLI Option
The SPC 2120 is designed to communicate with the 2120 in order to collect
point information. This information is written to a file for the 4120 programmer
to interpret for easier 4120 GCC point expansion.
Before you install the SPC 2120 software onto the PC, check to ensure that it
meets the following minimum requirements:
•
80386 or greater processor
•
640 K RAM
•
Hard disk with at least 350 K free
•
One 3.5" floppy drive for installation purposes
•
One available serial (COM) port
•
One 2120 Serial cable, to be connected to a 2120 Computer port.
Use the following procedure to install the SPC 2120.
1.
Insert the 3.5" program diskette into your floppy drive.
If you are using a Windows 95 Operating System, open an MS-DOS
command window by selecting the Start button, then the Program menu
choice. Choose MS-DOS Prompt from the Program menu.
2.
From the C:\ or C:\WINDOWS prompt type A:install and press Enter.
3.
From the installation screen select I to install the SPC 2120 or E to exit the
installation.
4.
The SPC 2120 installation program then asks you where you wish the utility
installed. The typical installation is installed in the C:\SPC2120 directory.
5.
After a successful installation, the SPC 2120 installation program returns
you to the DOS prompt.
3-15
firealarmresources.com
Continued on next page
Advertisement
Table of Contents
