Table of Contents
Advertisement
Verifying the Tape Drive Installation
Verifying Tape Drive
Installation (Optional)
Verify that the tape drive has been installed, as follows:
1.
Verify that no jumper exists on the tape drive jumpers DSP, DS0, or DS1.
2.
Install the Tape Drive into the GCC as defined in the IOMEGA instruction
manual.
3.
Disconnect the connector from the GCC floppy and connect it to the
connector on the tape drive.
6-13
firealarmresources.com
Advertisement
Table of Contents
Need help?
Do you have a question about the 4190 Graphical and is the answer not in the manual?
Questions and answers