Table of Contents
Advertisement
Installing the Software
Installing Windows 95
AUTOEXEC.BAT File:
CMOS Setup:
Taskbar:
Virtual memory:
If Windows 95 operating system software must be installed on your computer,
follow the instructions given in the Microsoft documentation for this product.
After the Windows 95 operating system has been installed, modify the computer
for GCC operation in the following manner.
Modify the AUTOEXEC.BAT file as follows:
1.
Click on the Start button and select Programs - MS DOS Prompt.
2.
At the C:\WINDOWS> prompt, type cd\.
3.
At the C:\> prompt, type EDIT AUTOEXEC.BAT and press ENTER. The
AUTOEXEC.BAT file is displayed on the text editor screen.
4.
At the bottom of the AUTOEXEC.BAT file, enter the following line:
SCANDISK/ALL/AUTOFIX/NOSUMMARY
5.
Save the AUTOEXEC.BAT file and exit.
6.
If using a 200 Mhz to 700 Mhz PC, log on to the Tech Service Web Page
and go to Support Information and Downloads>Fire
Alarm>Downloads>GCC/NPU>Utilities and download the GCCKEY.exe
file.
Modify the CMOS Setup as follows:
1. Select Peripheral Setup.
2.
Change On-Board IDE entry from BOTH to PRIMARY.
3. Select PCI/PNP Setup.
4.
Change IRQ 5, 9, 10, 11, 15 from PCI/PNP to ISA/EISA.
5.
Press <ESC>, "Save Changes and Exit."
Modify the Taskbar as follows:
1.
Click on the Start button and select Settings, then Taskbar, then Start Menu.
2.
Remove Checkmark (á) from "Always on top."
Display:
Set the Display options as follows:
1.
Click on the Start button and select Settings, then the Control Panel menu.
2.
Double-Click the Display icon.
3.
Under the Settings tab, set the "Desktop Area" to 800 by 600 pixels. Click
on Apply. Windows will ask you to test-view the new setting, then make
the change.
4.
Under the Screen Saver tab, set the Screen Saver selection to (None).
(Alarm messages on the computer screen can not be seen when the Screen
Saver is running)
Verify the Virtual Memory Settign as follows:
1.
Click o the Start buton and select Settings, then the Control Panel menu.
2.
Double-Click the System icon.
3.
Under the Performance tab, click on the Virtual Memory button.
4.
Make sure the selection "Let Windows manage my virtual memory settings"
is made.
firealarmresources.com
3-3
Continued on next page
Advertisement
Table of Contents
