Connecting The Target System - Renesas Emulation Pod M3062NT3-RPD-E User Manual

3.8 Connecting the Target System

There are several ways available to connect the emulation pod to target systems as shown in Figure 3.12.
80-pin
0.65-mm-pitch
M30800T-PTC
(included)
M3T-100LCC-DMS
(not included)
M3T-FLX-DCT613
(not included)
M3T-DIRECT80S M3T-FLX-80QSB
80-pin QFP 80-pin QFP
(not included) (not included)
: No. 1 pin
*1: These three products are in one package.
Figure 3.12 Connecting the target system
Notes on Connecting the Target System:
0.65-mm-pitch
M30800T-PTC
(included)
M3T-FLX100-T
(not included)
LCC socket M3T-DIRECT100S M3T-DUMMY100S
100-pin LCC 100-pin QFP 100-pin QFP
(included) (not included) (not included)
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
Emulation pod probe
100-pin
M3T-100LCC-DMS
(not included)
M3T-FLX100-R
(not included)
*1
M3T-FLX-100NRB M3T-F160-100NSD
100-pin QFP 100-pin LQFP
(not included) (not included)
CAUTION
( 41 / 84 )
0.5-mm-pitch
M30800T-PTC
(included)
M3T-100LCC-DMS
(not included)
M3T-FLX100-T M3T-FLX100-R
(not included) (not included)
M3T-100LCC-QSD M3T-FLX-100NSD M3T-F160-100NSE
100-pin LQFP 100-pin LQFP
(not included) (not included)
0.4-mm-pitch
100-pin TQFP
(not included)