Jumper Switches Jp1 And Jp2 On The M30620T3-Prt Board (Mcu-Dependent 1) - Renesas Emulation Pod M3062NT3-RPD-E User Manual

(2) Jumper Switches JP1 and JP2 on the M30620T3-PRT Board (MCU-dependent 1)

Table 3.4 Switch settings of the M3062NT3-RPD-E (3/3)
Signal Switch
JP1
A18_SEL
VDDI0 JP2
Note on Switch Settings:
• Always shut OFF power before changing switch settings.
Setting
Use this setting when not using the memory
(Factory-setting)
space expansion mode.
Use this setting when using the memory
space expansion mode.
(Factory-setting)
Use this setting.
Do not use this setting.
CAUTION
( 36 / 84 )
Description