Connecting Qb-Rl78L12 To Target System - Renesas QB-RL78L12 User Manual

QB-RL78L12 In-Circuit Emulator

2.5 Connecting QB-RL78L12 to Target System

If connecting the emulation probe (QB-80-EP-01T, QB-144-EP-02S), connect it to the QB-RL78L12 and the target
system by the following procedure.
(a) Connect the QB-RL78L12 to the probe.
Connect the emulation probe to the QB-RL78L12, as shown below.
Insert CN1, CN2 and CN3 of the probe into TCN1, TCN2 and TCN3 of the QB-RL78L12
In case of using QB-144-EP-02S, use probe holder.
(b) Connection of emulation probe GND wire
There are three GND wires in the emulation probe. Connect them to the QB-RL78L12 and target system.
<1> Fasten the GND wire on the QB-RL78L12 side of the emulation probe to the nut on the bottom of
the QB-RL78L12 using a #0 or #1 Phillips precision screwdriver (connection of B to A in Figure 2-8).
<2> Next insert the connector on the top of the emulation probe into the connector at the opening on
the bottom of the QB-RL78L12 from below being careful of the insertion direction.
R20UT2080EJ0100 Rev.1.00
2013.03.18
Figure 2-7 Connect the QB-RL78L12 to the probe
QB-80-EP-01T
Figure 2-8. GND Wire
CHAPTER 2 SETUP PROCEDURE
QB-RL78L12
Page 30 of 42