Connecting To A 100-Pin 0.4-Mm-Pitch Foot Pattern - Renesas Emulation Pod M3062NT3-RPD-E User Manual

(10) Connecting to a 100-pin 0.4-mm-pitch Foot Pattern

Here follows how to connect the emulation pod probe to a 100-pin 0.4-mm-pitch foot pattern on the
target system with the M3T-F160-100NSE (not included). For details on the M3T-F160-100NSE
(not included), refer to its user's manual.
(1) Mount the NQPACK100SE included with the M3T-F160-100NSE to the target system.
(2) Attach the YQPACK100SE included with the M3T-F160-100NSE to the NQPACK100SE,
and secure it with YQ-GUIDE's.
(3) Attach the CN2 side of the M3T-F160-100NSE to the tip (CN2 side) of the pitch converter
board connected to the emulation pod probe.
(4) Attach the M3T-F160-100NSE to the YQPACK100SE.
These four parts are in one package.
These corners are not round.
Figure 3.22 Connecting to a 100-pin 0.4-mm-pitch foot pattern
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The connectors of the M3T-F160-100NSE are guaranteed for only 50 insertion/
removal iterations.
Tip of emulation pod probe
Tip of pitch converter board
CN2 side
(3)
M3T-F160-100NSE (not included)
(4)
YQ-GUIDE's (x4)
YQPACK100SE
NQPACK100SE
(2)
100-pin 0.4-mm-pitch (100PFB-A) foot pattern
(1)
No. 1 pin
CAUTION
( 51 / 84 )
Onboard evaluation
HQPACK100SE
(not included)
Flash version MCU etc.
Target system