Turning On The Power; Checking Connections Of The Emulator System; Turning On/Off The Power - Renesas Emulation Pod M3062NT3-RPD-E User Manual

Chapter 4. Usage

4.1 Turning On the Power

(1) Checking Connections of the Emulator System

Before turning the power ON, check the connections of the PC4701, emulation pod, converter board
and target system.

(2) Turning ON/OFF the Power

• Turn on the power of the emulator and target system as simultaneously as possible.
• Turn off the power of the emulator and target system as simultaneously as possible.
• Do not leave either the emulator or target system powered on, because of leakage current the
internal circuits may be damaged.
• When turning on the power again after shutting off the power, wait about 10 seconds.
Notes on Power Supply:
• Pin Vcc of the emulator is connected to the target system to observe the voltage of
the target system. Therefore design your system so that the target system is powered
by an external power supply.
• The voltage of the target system should be within the MCU's specified range.
• Do not change target system power supply voltage after power has been activated.
( 54 / 84 )
CAUTION