Table of Contents
Advertisement
QB-RL78F14 In-Circuit Emulator
2.5 Connecting QB-RL78F14 to Target System
If connecting the emulation probe (QB-80-EP-01T, QB-144-EP-02S), connect it to the QB-RL78F14 and the target
system by the following procedure.
(a) Connect the QB-RL78F14 to the probe.
Connect the emulation probe to the QB-RL78F14, as shown below.
Insert CN1 and CN2 of the probe into TCN1 and TCN3 of the QB-RL78F14.
In case of using QB-144-EP-02S, use probe holder.
QB-80-EP-01T
(b) Connection of emulation probe GND wire
There are three GND wires in the emulation probe. Connect them to the QB-RL78F14 and target system.
<1> Fasten the GND wire on the QB-RL78F14 side of the emulation probe to the nut on the bottom of
the QB-RL78F14 using a #0 or #1 Phillips precision screwdriver (connection of B to A in Figure 2-8).
<2> Next insert the connector on the top of the emulation probe into the connector at the opening on
the bottom of the QB-RL78F14 from below being careful of the insertion direction.
R20UT2058EJ0300 Rev.3.00
Oct 31, 2013
Figure 2-7. Connect the QB-RL78F14 to the probe
Figure 2-8. GND Wire
CHAPTER 2 SETUP PROCEDURE
Probe holder
QB-144-EP-02S
QB-RL78F14
Page 30 of 41
Advertisement
Table of Contents
