Connecting Qb-Rl78I1A To Target System - Renesas QB-RL78I1A User Manual

QB-RL78I1A In-Circuit Emulator

2.4 Connecting QB-RL78I1A to Target System

If connecting the emulation probe (QB-80-EP-01T), connect it to the QB-RL78I1A and the target system by the
following procedure.
(a) Connect the QB-RL78I1A to the probe.
Connect the emulation probe to the QB-RL78I1A, as shown below.
Insert CN1 and CN2 of the probe into TCN1 and TCN3 of the QB-RL78I1A.
(b) Connection of emulation probe GND wire
There are three GND wires in the emulation probe. Connect them to the QB-RL78I1A and target system.
<1> Fasten the GND wire on the QB-RL78I1A side of the emulation probe to the nut on the bottom of
the QB-RL78I1A using a #0 or #1 Phillips precision screwdriver (connection of B to A in Figure 2-6).
<2> Next insert the connector on the top of the emulation probe into the connector at the opening on
the bottom of the QB-RL78I1A from below being careful of the insertion direction.
R20UT0766EJ0200 Rev.2.00
2012.03.30
Figure 2-5. Connect the QB-RL78I1A to the probe
Figure 2-6. GND Wire
CHAPTER 2 SETUP PROCEDURE
Page 27 of 38