Build Commands - Cablescan 4000C Instruction Manual

Model 4000C Instruction Manual

Build Commands

The following commands relate to using the assembly features of the Model 4000C. These
modes use Body Conductance to locate desired wires for assembly. At the system prompt, enter
the two-letter command, followed by an ENTER.
Tester
Function
Random Build
Sequential Build
Search
Random Build - RA
Same as RANDOM BUILD on the Front Panel. See section on Controls and Displays for more
details.
Sequential Build - SQ
Same as SEQ BUILD on Front Panel. See section on Controls and Displays for more details.
Execution of this command begins at the first sequence step programmed into the wire list table.
To start the Sequential Build at a step other than the first, enter the SQ command followed with a
SPACE, then enter the sequence number followed by ENTER.
Search - SB
Same as SEARCH selected from the Front Panel menu. See section on Controls and Displays
for more details.
2-letter
Command
RA
SQ
SB
Entering a Sequence Number
Command
Description
Random Assembly
Sequential Assembly
Scan Body
Page 34