Table of Contents
Advertisement
Model 4000C Instruction Manual
operation the display will show RECORDING TAPE. After the program has been recorded
the tape will rewind and a verification will be performed; the display will read VERIFYING
TAPE followed by VERIFY COMPLETE.
Format Drive 0
Before a new disk can be used to save data, it must be initialized (formatted) using this
function.
1. Insert a new or unused diskette in the internal 3.5-inch drive. All data currently on the
diskette will be erased.
2. Rotate ENABLE keyswitch to vertical position (enabled position).
3. Select and initiate sub-menu mode by pressing the up or down arrow until SUB-MENU
is displayed and press MENU RUN.
4. Press arrow key to display FORMAT DRIVE 0, and press MENU RUN. ARE YOU
SURE? message will display.
5. Press MENU RUN a second time to initiate format function.
displayed during operation. Pressing any other key is a no response, and the format
function is terminated. After formatting, COMPLETE – READY will displayed.
Format Drive 1
This function is used to format a diskette if the Model 4000C has an external disk drive
connector and an external disk drive is connected,. The operation of this function is identical
to the Format Drive 0 described above.
Default System Settings
This function is used to default the Tester setup parameters to preprogrammed values. An
ARE YOU SURE? message is displayed after this function is initiated with the MENU RUN
key. Pressing the MENU RUN key again (yes) will default the parameters to the values
below.
Maximum Transmit Point
Maximum Receive Board
Start Point
Scan Clock Speed
Scan Delay Count
Learn Clock Speed
Retest Delay
Retest flag
=
128 x number of scanner boards installed
=
number of boards installed
=
1
=
12 (20 µs)
=
100 (1200 µs)
=
10 (28 µs)
=
100 (1200 µs)
=
2 (ON)
Page 31
FORMATTING is
Advertisement
Table of Contents
