Data Format; Terminal Cable - Cablescan 4000C Instruction Manual

Model 4000C Instruction Manual

Data Format

If the terminal was not supplied by Cablescan, the following setup data are required:
Transmission to the terminal is at 9600 Baud, with 8 data bits, 1 stop bit, no parity.

Terminal Cable

The terminal interface cable is not wired one-to-one. Data Out from the tester must be connected
to Data In on the terminal and Data In on the tester must be wired to Data Out on the terminal.
Both the Model 4000C and the Terminal have 25-pin D-type female connectors; therefore, the
interface cable has male connectors on both ends. The cable is wired as follows:
Function
Data In
Data Out
Signal Ground
(Terminal Interface Cable P/N 5210789)
Pin numbers 2 and 3 are crossed.
Pin number 7 is connected directly.
Tester Terminal
25-Pin 'D' 25-Pin 'D'
2 3
3 2
7 7
NOTE
Page 18