Wire List Programming; Editor Start-Up; User Notation Table - Cablescan 4000C Instruction Manual

Model 4000C Instruction Manual

WIRE LIST PROGRAMMING

When the wire harness documentation and the fixture wiring information are available, the Wire
List can be programmed. In most cases it is best to begin by entering the User Notation Table.
A label assigned in the User Notation Table must match exactly with the corresponding label
used in the Wire List. The Model 4000C will display "not found" if a label is entered as the
From or To point in the wire list and is not assigned to a point number in the User Notation
Table.
The Model 4000C provides room for 8 character labels. If your labels are over 8 characters, plan
to abbreviate them before you begin programming. Also, shorter labels are easier for the
operator to read.

Editor Start-up

Connect the CRT/Terminal or PC as described in the Preparation section. Follow the procedure
below:
1. Press ESC to display the system prompt, >.
2. Type ED, and press ENTER. The last lines should be as shown below:

 ED
EDIT (W, U)

User Notation Table

1. To edit the User Notation Table, press U. (Do not press ENTER.) The monitor should
display two more lines as shown below:

 ED
EDIT (W, U)
EDIT User Notation List
U 0001
The editor is in the Cursor Positioning mode when it is first
entered. The left column indicates which table is being edited
and the current mode. The Cursor Positioning mode is denoted
in the wire list table when only a U is displayed as shown above.
The Replace mode is indicated with an RU, while the Insert or
Add mode is indicated by an IU or AU.
JA-32
NOTE
Page 58