Find - F (Point Number); Find - F (From Point) (To Point); Find Wire Number - Fw Xxx; Sort Tables - So - Cablescan 4000C Instruction Manual

Model 4000C Instruction Manual

Find - F (point number)

Finds a specified point number, or user notation, denoted by (point number). Use a numeric
number to locate the tester point number. Use an alphanumeric number to locate the user label.
This command can be used in either the Wire List Table or the User Notation Table. The search
is started from the cursor position to the last point. To search the entire table, back the cursor to
the start of the table. This can be done by typing FS 1, followed with an ENTER.

Find - F (From Point) (To Point)

Finds a specified wire (circuit) denoted by the From Point/To Point pair. Use numeric numbers
to locate the tester point number. Use alphanumeric numbers to locate the user notation labels. If
the F command is entered without point number(s), the last point number data entered for the
previous find command will be used.

Find Wire Number - FW XXX

This command is used only in the Wire List Table to find a specific wire number (circuit label).
This command locates a string of characters that have been assigned in the circuit label field. If
the FW command is entered without a circuit label, the last circuit label entered with the FW
command will be searched. Search is started from the cursor position to the end of the table. To
search the entire table, back the cursor to the start of the table by entering FS 1 followed with an
ENTER. Consecutive FW commands will find every occurrence of the circuit label string in the
table. If the string is not found between the cursor and the end of table, the display will read
NOT FOUND.

Sort Tables - SO

Whenever a change is made to the Wire List Table, a sort operation must be done before a Test
or a Record can take place. This is done automatically by the system. At times you may see
SORTING PT-PT TABLE when you press TEST or RECORD. If the table has not been sorted,
an automatic sort will take place. This table is stored in ascending order and cannot be edited by
the user. By entering the print command PS, a list of this table can be printed. This printout will
also group all multiple circuits.
Page 50