Table of Contents
Advertisement
Model 4000C Instruction Manual
MODEL 4000C
VOLUME
CONTINUITY TESTER
RANDOM
- Initiates circuit assembly in random by displaying circuit information
BUILD
(termination) as each wire is touched while the wrist strap is attached.
SEQ BUILD
- Initiates circuit assembly in step-by-step sequence per wire list arrangement
in memory. The assembly sequence is programmed using the Wire List
Editor.
SEARCH
- Initiates a scan of the test points using Body Conductance to identify wire
touched.
ERROR LIST
- Initiates test and produces a printout of errors, or prints "Passed" if no
errors.
- Initiates single test of assembly and displays errors.
TEST
- Terminates current mode and places Tester in "wait" state until next mode
RESET
selection is made.
- Used for stepping up and down through menu to select one of several modes
UP/DOWN
available.
ARROWS
Used to step through file names when loading from disk.
- Initiates the menu mode (selected by Up/Down Arrows) that appears in the
display.
MENU RUN
Used to load file from disk after the file name is displayed.
- Scans the connected (known-good) assembly and saves the continuities in
KNOWN
memory.
GOOD
- Reads a recorded tape into memory. (This mode is retained from earlier
FROM TAPE
systems.
- Switches control to an optional CRT/keyboard Terminal or PC.
REMOTE
RANDOM
SEQ.
SEARCH
BUILD
BUILD
MENU
RUN
Figure 1. Front Panel Controls and Display
ERROR
TEST
RESET
LIST
KNOWN
FROM
REMOTE
GOOD
TAPE
Page 9
ENABLE
PROBE
EARPHONE
Advertisement
Table of Contents
