Changing Set-Points; Processor Cycle - Kodak X-Omat 460 RA Operator's Manual

Changing Set-Points

Processor Cycle

Description
Procedure
636736
This procedure, and the three procedures following it, explain how to change process
variables whose set-points were preset at the factory. In most cases factory set-points
will provide optimum film processing.
Set-Points are stored for each cycle. Changing
a set-point changes it for only the selected cycle.
[1] To select the processor cycle for either RP or RA chemistry, press the ''GO
TO SETUP'' key.
READY
135 F = DRYER SETPOINT
_______________________________________
|
/\ \/
|
DRYER DRYER
|
[2] Enter the 4 digit access code.
|
|
1 2
|
[3] Press the ''CYCLE'' key.
|
SETUP
|
CYCLE PROCESS
|
[4] Select the desired operating cycle—
(a) If using RP chemistry, press—
1. ''RAPID CYCLE'' key for the rapid cycle.
2. ''STD CYCLE'' key for the standard cycle.
3. ''EXT CYCLE'' key for the extended cycle.
(b) If using RA chemistry, press the ''K/RA CYCLE'' key.
|
RAPID STD
|
CYCLE CYCLE
|
[5] Immediately, press the ''DONE/RETURN'' key to store the entry.
IMPORTANT
STD
| | |
SELECT DISPLAY GO TO
| | |
CYCLE FIX SETUP
| | |
TEMP
| | |
CANCEL
| | |
3 4 REQUEST
| | |
| | |
DONE/
| | |
OPTIONS LANG RETURN
| | |
| | |
EXT K/RA DONE/
| | |
CYCLE CYCLE RETURN
| | |
23