Status Information - Kodak X-Omat 460 RA Operator's Manual

Status Information

4
The display panel provides the following status information for the processor:
• Liquid Crystal Display
• Ready/Not Ready
• Message/Error
• Current cycle
• Current function for each of the ''Soft Keys''
• Operation Status LEDs
• The ''Ready'' LED indicates that the processor is ready to accept film.
• The ''Wait'' LED indicates that the processor has not yet reached its optimum film
processing conditions. See page 34 for a further description of ''Wait'' conditions.
• The ''Service'' LED indicates that the processor has an error that the operator
cannot repair.
• Indicators
• The Developer Temperature Display shows the current temperature of the
developer solution in the processor tank in degrees celsius or fahrenheit. If the
temperature appears in degrees celsius, it indicates that you are operating in the
metric system and that travel speed will be displayed in centimeters per minute.
• The Replenishment Indicator illuminates whenever both the Developer and Fixer
Pumps are operating.
The display panel has 5 keys called ''Soft Keys'' that allow you to select, change, and
monitor processor variables. These keys are located just below the Liquid Crystal
Display (LCD).
READY/NOT READY
MESSAGE/ERROR
_______________________________________
|
SOFT SOFT
|
KEY KEY
|
After you have made a selection from the menu displayed on the LCD, the functions of
the first 4 keys change to describe the next lower level menu selections. Any key that
is not used will be blank. Pressing the fifth key, ''DONE/RETURN'', completes the
entry and displays the next upper level menu on the display panel. See page 45 to
view the menu flowchart for the processor display panel. In addition, each
procedure in this manual shows the step-by-step readout of the LCD after each key
selection.
CURRENT CYCLE
| | |
SOFT SOFT SOFT
| | |
KEY KEY KEY
| | |
636736