Shutdown; Daily Cleanup - Kodak X-Omat 460 RA Operator's Manual

Shutdown

Daily Cleanup

636736
[1] Move the main circuit breaker, CB1, to the ''O'' position.
[2] Move the wall power switch to the ''OFF'' position.
[3] Turn off the water supply.
[4] Perform the ''Daily Cleanup'' procedure.
Reliable operation of the processor requires that all parts are cleaned
Wear rubber gloves, safety glasses, and protective clothing when doing
any daily maintenance procedure. Report any change in the operating
condition of the processor to your service personnel.
[1] Move the main circuit breaker, CB1, to the ''O'' position.
[2] Move the wall power switch to the ''OFF'' position.
[3] Disconnect the water hoses from the crossovers.
Handle these assemblies carefully to prevent changing their alignment.
DO NOT clean the racks, crossover assemblies, or squeegee rollers
using abrasive materials. Do not wash the roller racks and assemblies
with water hotter than 100°F (37.5°C).
[4] Remove the evaporation covers, both crossovers, and the squeegee
assemblies.
[5] Clean these parts with warm water and a damp cloth.
[6] Dry all the parts with a clean cloth and allow the parts to air dry overnight.
[7] Use a clean cloth to wipe all chemical residue from the processing section of
the processor. To prevent contamination, do not use the same cloth for the
fixer and developer sections.
[8] Leave the top cover open approximately 5.1 cm (2 inches) overnight to allow
the parts to completely dry.
39