Heartland VALUE Series Assembly Manual page 58

PARTS REQUIRED:
3/4" GAUGE
BLOCK
Roof panels may cause serious injury until securely fastened.
Note: Install all roof panels with the rough side up (painted grid lines).
BEGIN
1
Place the 48" x 96" panel
on rafters with a 3/4"
measurement on the rafter
(Fig A) and the panel flush
at the peak (Fig. B).
Secure panel with (1) 2" nail
in each corner.
2
Move to the opposite end.
Using the long edge of the panel
as a lever, move the panel side-
to-side until the top corner is
flush to the peak (Fig. B).
Move gable end rafter edge until
it is 1/2" from the 48" x 47-7/8"
roof panel (Fig. C).
Secure panel with (1) 2" nail in
each corner.
10' x 18' ROOF PANELS
x1
Gauge Block
Fig. A
3/4"
(1,9 cm)
1/2"
(1,2 cm)
Fig. C
48 x 96"
(121,9 x 243,8 cm)
Gable
End Rafter
56
x4
2" (5,1 cm)
Flush at
peak
Fig. B
Two
Nails
Fig. B
Two
Nails
Flush at
peak