Heartland VALUE Series Assembly Manual page 45

10x10' 10x14' 10x18'
x10
x14
x18
x12 x16
x20
x216
x120 x168
BEGIN
Measure 120-11/16 (306,5 cm) from the corner and install RL with (2) 3" screws.
1
Place two rafter-halves on floor and flush in the corners of wall and RL.
Flush rafters at peak. Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
Flush
1/4" 1/4"
(1,9 cm) (1,9 cm)
Fig. A
SET ASIDE THESE TWO RAFTER ASSEMBLIES.
Depending on your shed size, build 4 , 6 or 8 rafter assemblies with (2) gussets (Fig. C).
Place two rafter-halves on floor and flush in the corners of wall and RL, as shown in STEP - 1.
2
Flush rafters at peak. Secure gusset to rafters with 2" nails following the pattern shown (FIg. A).
3
Flip over rafter assembly and fasten second gusset to other side with 2" nails (FIg. C).
Fig. B -
Build 2
FINISH
Your rafters are now assembled.
Remove RL and screws from floor.
RAFTERS
PARTS REQUIRED:
6 x 24" (15,2 x 60,9 cm)
Pre-assembled
2" (5,1 cm)
Build (2) rafter assemblies with(1) gusset (Fig. B).
Flush
in corner
x2
x1 RL
2 x 4 x 24" (5,1 x 10,2 x 61 cm)
120-11/16"
(306,5 cm)
Fit base of rafters in corner
of 10' wall and RL.
Flush at peak
Fig. C -
Build 4, 6 or 8
43
3" (7,6 cm)
Temporary Support
HINT:
Use floor and walls to help
assemble rafters!
in corner
Temporary
Support
RL
Flush
3" (7,6 cm)
Screws