Table of Contents
Advertisement
Section 21
Requirements
•
One master clock for the actual network
•
The actual port Synchronized to the SDH system clock at 2048 kbit
•
Synchronization; bit synchronized, synchronized mapping
•
Maximum clock deviation <±50 ppm nominal, <±100 ppm operational
•
Jitter and Wander according to ITU-T G.823 and G.825
•
Buffer memory <250 μs, <100 μs asymmetric difference
•
Format.G 704 frame, structured etc.Format.
•
No CRC-check
Synchronization in PDH systems connected to SDH systems
•
Independent synchronization, asynchronous mapping
•
The actual SDH port must be set to allow transmission of the master clock from the PDH-
system via the SDH-system in transparent mode.
•
Maximum clock deviation <±50 ppm nominal, <±100 ppm operational
•
Jitter and Wander according to ITU-T G.823 and G.825
•
Buffer memory <100 μs
•
Format: Transparent
•
Maximum channel delay
•
Loop time <40 ms continuous (2 x 20 ms)
IED with echo synchronization of differential clock (without GPS clock)
•
Both channels must have the same route with maximum asymmetry of 0,2-0,5 ms,
depending on set sensitivity of the differential protection.
•
A fixed asymmetry can be compensated (setting of asymmetric delay in built in HMI or the
parameter setting tool PST).
IED with GPS clock
•
Independent of asymmetry.
21.6
IEC/UCA 61850-9-2LE Merging unit requirements
The merging units that supply the IED with measured values via the process bus must fulfill the
IEC/UCA 61850-9-2LE standard.
This part of the IEC 61850 is specifying "Communication Service Mapping (SCSM) – Sampled
values over ISO/IEC 8802", in other words – sampled data over Ethernet. The 9-2 part of the
IEC 61850 protocol uses also definitions from 7-2, "Basic communication structure for
substation and feeder equipment – Abstract communication service interface (ACSI)". The set
of functionality implemented in the IED (IEC/UCA 61850-9-2LE) is a subset of the IEC
61850-9-2. For example the IED covers the client part of the standard, not the server part.
The standard does not define the sample rate for data, but in the UCA users group
recommendations there are indicated sample rates that are adopted, by consensus, in the
industry.
There are two sample rates defined: 80 samples/cycle (4000 samples/sec. at 50Hz or 4800
samples/sec. at 60 Hz) for a merging unit "type1" and 256 samples/cycle for a merging unit
"type2". The IED can receive data rates of 80 samples/cycle.
Note that the IEC/UCA 61850-9-2LE standard does not specify the quality of the sampled
values, only the transportation. Thus, the accuracy of the current and voltage inputs to the
merging unit and the inaccuracy added by the merging unit must be coordinated with the
requirement for actual type of protection function.
458
1MRK 505 370-UEN D
SEMOD166590-11 v5
Busbar protection REB670
Application manual
Advertisement
Table of Contents
