Table of Contents
Advertisement
1MRK 505 370-UEN D
IEC17000044 V1 EN-US
Figure 206: Merging unit
16.3.2
Setting guidelines
For information on the merging unit setting guidelines, see section
communication
16.4
Routes
16.4.1
Application
Setting up a route enables communication to a device that is located in another subnetwork.
Routing is used when the destination device is not in the same subnetwork as the default
gateway.
The route specifies that when a package is sent to the destination device it should be sent
through the selected router. If no route is specified the source device will not find the
destination device.
16.4.2
Setting guidelines
Routes are configured using the Ethernet configuration tool in PCM600.
Operation for the route can be set to On / Off by checking and unchecking the check-box in the
operation column.
Gateway specifies the address of the gateway.
Destination specifies the destination.
Destination subnet mask specifies the subnetwork mask of the destination.
Busbar protection REB670
Application manual
IEC17000044-1-en.vsdx
protocol.
Section 16
Ethernet-based communication
GUID-3449AB24-8C9D-4D9A-BD46-5DDF59A0F8E3 v1
IEC/UCA 61850-9-2LE
GUID-19616AC4-0FFD-4FF4-9198-5E33938E5ABD v1
GUID-2C4A312A-00DC-44C8-B2D9-CD0822E1C806 v1
391
Advertisement
Table of Contents
