Table of Contents
Advertisement
Field Name
Description
*L2TP (CAT6/7 Only)
BCP Support
Enable/Disable Bridge Control Protocol for L2TP tunneling. If enabled, must be set up on
both ends, the CPE/router acting as Point-to-Point Protocol (PPP) client and the PPP
server.
L2TP Server IP
IP address of the L2TP server
L2TP User
L2TP server user name
L2TP Password
L2TP server password
DNS Mode (CAT6/7 Only)
DNS Mode
Automatic or Manually. If you select Automatic, the CPE will automatically search the
domain name on the first available DNS server. If you select Manually, enter the primary
and secondary DNS server IP addresses.
Primary DNS
If DNS Mode was set to Manually, enter the primary DNS server's IP address for the CPE
to check first for domain name resolution.
Secondary DNS
If DNS Mode was set to Manually, enter the secondary DNS server's IP address for the
CPE to check after the primary DNS if the domain name was not resolved.
6.4 Configure WLAN Settings
The Baicells Atom indoor CPEs have an embedded Wi-Fi access point, providing converged Wireless LAN
(WLAN) and LAN interfaces into one integrated LTE service. The Wi-Fi uses 2.4 GHz unlicensed spectrum
and is compliant with IEEE 802.11b/g/n.
You can enable WLAN and configure up to four independent Service Set Identifiers (SSIDs) on the local
network. This allows you to customize the settings for each SSID.
To set up WLAN for CAT4:
1. Ensure that the computer or other smart device connecting to the CPE has WLAN/Wi-Fi enabled.
When the Wi-Fi LED on the unit shows "steady on", per Table 2 LEDs, it is functional.
2. In the GUI, go to Network > WLAN Settings to the Wireless Overview page. Then click SETTINGS to
open the Wlan 2.4G page (Figure 13).
3. To avoid unauthorized use of the Wi-Fi/WLAN, enter a unique access password. Refer to the
CPE Configuration Guide
for a description of all the settings.
15
Advertisement
Table of Contents
