Table of Contents
Advertisement
•
Lan State - The CPE connection to the Local Area Network will be either Link Up or Link Down. If
the link is down, recheck the installation steps, make sure the CPE is powered on, and check the
router or other LAN device operation.
•
Devices Connected - A count of the number of different smart devices using the CPE
4.
Connect Wi-Fi:
a.
Ensure that the computer or other smart device has Wi-Fi (WLAN) enabled.
b. When the Wi-Fi LED on the unit shows "steady on", per Table 2, it is functional. The Wi-Fi function
can be enabled or disabled through the GUI.
c.
Looking at the label on the back of the Atom unit, record the WLAN Name and WLAN Key
(WPA/WPA2) values (Figure 9).
Figure 9: Label
6.3 Configure WAN Settings
The Network > WAN Settings pertain to:
•
How the CPE interfaces with the Wide Area Network (WAN) - typically the Internet;
The network or operation mode, which determines how IP addressing is handled; and
•
•
The Domain Name System (DNS) to be used.
Because the GUI screens for the WAN settings are laid out differently between CAT4 and CAT6/7, each is
described separately in the sections below. Refer to Table 4 for a description of all fields in both GUIs.
To avoid unauthorized use of the Wi-Fi/WLAN, go
to the GUI and modify the WLAN Name and Key
(WPA/WPA2) information from your service
provider. These fields are case-sensitive. On your
Wi-Fi enabled computer and other smart devices,
you can then look for the new Wi-Fi/WLAN
network name.
8
Advertisement
Table of Contents
