Configure Quick Settings - Baicells Nova436Q Installation Manual

Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide

3.8.6 Configure Quick Settings

The Basic Setting > Quick Setting sub-menu (Figure 3-32) is used to configure important RF parameters
and connectivity to the Baicells CloudCore Evolved Packet Core (EPC). There are several important fields
you must configure and/or verify. First, if the operator is using the Baicells CloudCore EPC, you must enter
a fixed Public Land Mobile Network (PLMN) and MME IP address:
PLMN = 314030
•
• MME IP = 10.3.0.9 and 10.5.0.9
Do not change these settings except when connecting to a Local (private network) EPC or different
vendor's EPC. Second, you must enter the operator's planned settings for Band, Bandwidth, EARFCN, Cell
ID, PCI, TAC, etc. Some Quick Setting fields such as Duplex Mode and Frequency will auto-fill based on the
eNB hardware model. Make sure the Cloud EPC field is set to ON when using the Baicells CloudCore. If you
are testing the eNB in a lab environment, turn the power down as low as it will go under the Power Modify
field.
NOTE 1: If planning to use CBRS SAS, the SAS vendor will determine some of these parameters.
Refer to the SAS Deployment Guide
NOTE 2: Nova436Q does not support SFA = 0.
NOTE 3: Cloud EPC mode is enabled using the Network > Core Network menu.
For a description of all the eNB Quick Setting fields, refer to the
BaiBLQ.
for more information.
40
4G LTE eNodeB Configuration Guide –