If you wish to leave the scan mode as Full Band, you do not need to make any configuration changes for
the mode. The procedures for configuring the other three modes are described for CAT4 and for CAT6/7
in the sections that follow.
6.7.2 CAT4
Following are the procedures for configuring Frequency Lock, Cell Lock, and PCI Lock on a CAT4 CPE.
•
Frequency Lock (Figure 19)
1. For Scan Mode, select Frequency Lock from the pull-down menu.
2. Click on ADD LIST to open the Frequency Lock Setting pane.
3. Select the Band number, and enter the Earfcn.
4. Click on ADD. Then click SAVE & APPLY.
Figure 19: Frequency Lock (CAT4)
23