Table of Contents
Advertisement
•
PCI-only Lock (Figure 24)
1. For Scan Mode, select PCI-only Lock from the pull-down menu, and click on Apply.
2. In the PCI Setting pane, enter the PCI Start and PCI End numbers.
3. Click on Apply. The configuration will appear in the PCI List in the bottom pane.
Figure 24: PCI-only Lock (CAT6/7)
6.8 Configure APN Management / Edit APN Profile
6.8.1 Overview
An Access Point Name (APN) is the name of a gateway between a device and another computer network,
frequently the public Internet. In a Baicells system where the operator uses the Baicells CloudCore to
connect to the backhaul, the APN establishes one connection between the CPE and the EPC (Evolved
Packet Core) via the eNB. The Baicells CloudCore EPC, as well as eNBs operating in HaloB mode, support
only one APN, which is configured by default. Therefore, when the service provider is using the Baicells
CloudCore, there is no need to change this setting.
When using a Local EPC (private network EPC), more than one APN can be established for connections to
multiple gateways. In this case, the CAT4 CPEs support up to four APN gateway configuration profiles, and
the CAT6/7 CPEs support up to eight.
28
Advertisement
Table of Contents
